Snapped!

With a combination of less-than-stellar quality of my rotary tool and my abusive treatment of it, the flex shaft snapped into halves. The shaft was enclosed in a plastic hose protected by springs on the outside, but I was running it for too long and the hose melted 🙁 I don’t know if I find a replacement for it. Just when I was getting the hang of it, yikes…

2 Replies to “Snapped!”

  1. That sucks! It always happens at the worst possible time too 🙁 Let me know if you need one of those Wave clones and I’ll get one out to you 😉

  2. Hey thanks so much! I think I’ll do ok since the seller is kind enough to send me a replacement. In the mean time I should really read up on what NOT to do with the flexshaft – like loading them with high resistant attachments and leaving them on for prolonged periods 😕

Leave a Reply

Your email address will not be published.

Loading Facebook Comments ...